Planning Items for Decoupage

Wooden

Lightly sand any tough places. Fill tough places and holes with wooden filler and then sand. Wipe with a damp sponge. If you want a stained track record, use a drinking water-soluble, liquor-based mostly wooden stain. You may well need to have to seal the wooden.

You can use your cutout specifically onto untreated wooden, but it&#39s superior to use a sealer. Prior to sanding wooden paint a foundation coat 1st as the drinking water-based mostly paint lifts the fibers of wooden way from the surface so when you sand the paint the fibers are simply taken out. The 1st coat of paint highlights imperfections that you can proper with filler.

When making use of a wooden foundation, keep in mind that oil and drinking water do not blend. The most popular decoupage glazes are drinking water-based mostly and will not adhere correctly to wooden that has been stained with an oil-based mostly stain.

If you&#39ve stained wooden with an oil-based mostly stain, you need to have to seal it with an oil-based mostly sealer. If you want to decoupage a piece of outdated furnishings and are not guaranteed the complete, uncover an inconspicuous location to check your glaze.

Glass

Wash your glass merchandise with soap and drinking water, rinse comprehensively, and wipe dry. Wipe the surface with rubbing liquor or vinegar and enable to dry just before functioning on the surface. Do not contact the surface after it has been cleaned as oil from fingers can lead to your visuals to not seal correctly.

You need to have to be excess watchful to take away any extra glue from the glass surface, after your prints are applied. It&#39s also really vital to do the job on a clean surface. When making use of PVA glue on glass, add a drop of glycerin to extend the drying time. After you have applied your cutout to the glass surface and allowed the glue to dry, you can take away any glue by wiping the glass with a window cleaner. Do not use glue to the impression, only to the glass. Do not fret about leaving way too a lot glue between the glass and the impression as it will dry clear. The extra glue you do the job with, the easier it is to get rid of bubbles. Likewise, it&#39s Okay to depart a skinny film of glue equally on the glass and the again of the impression.

Spray a modest amount of money on a damp sponge or fabric and take away any extra glue from the glass. Cotton swabs do the job properly to take away glue from modest parts.

Plastic

To decoupage on plastic, you need to have to roughen the plastic 1st with wallpaper. This will give it some tooth with which to get and provide a restricted seal. You will need to have to enable excess drying and excess curing time than with other surfaces. Dry to the contact is not adequate. Lightly push your finger in an space that will not show to check it if achievable. If not, enable quite a few times for drying to be on the protected facet. Retain the object secured versus dust when it&#39s drying.

Supply by Karen LeBlanc