How to Wallpaper Over a Brick or Cement Block Wall

The complications of concealing grouting and rough surfaces are easily triumph over. Lining paper, if properly utilized, will stretch in excess of and cover the rough patches and the effect can be concluded by working with a large or embossed wallpaper.

This procedure also applies to walls constructed of cement blocks. If you are building with brick or cement block and know that you want to wallpaper specified walls, check with your builders to implement the mortar so that you have a wonderful flat area, rather than raking out the joints. With current walls, the magic formula is in planning the uncooked area.

These are the instruments you are going to want:-

A prolonged table or bench, a trough, sponge or foam paste applicator, scissors, tender brush for smoothing wallpaper on to wall, a ruler, plumb line, razor for chopping.

A paint sealer is utilized to dry any dampness from the wall, then a latex centered wallpaper liquid size. A nicely soaked pre-pasted wallpaper lining will be just enough to soften the size and bond the lining firmly to the wall so that when wallpaper is pasted in excess of, it would not weaken in any way.

The similar principle can even be utilized if you are papering in excess of rough-caste walls (walls that have been plastered and raked or scrolled on when soaked). If your brick wall has an particularly rough and raised area it will have to be plastered in excess of prior to wall-papering.

Listed here is how it’s completed:-

one. Prior to start off doing the job on an absorbent uncooked wall, you happen to be to start with phase is to seal and size the wall. Coat it with a paint sealer and leave to dry right away. Subsequent implement a latex centered wallpaper liquid size this is specifically fantastic on absorbent surfaces. This will take about an hour to dry. If time is shorter you can implement two coats leaving an hour among coats, rather of the in excess of- evening sealer.

two. Implement pre-pasted lining paper. Soak it in a trough to soften and roll out to arm’s size. Fold in excess of and back again 50 %-way, forming pleats to the stop of the roll.

3. Keeping the major piece of paper in a person hand, and pleats in the other, stretch the to start with pleat together the wall and flatten out with sponge. Stretch future fold and flatten and so on to the stop of the roll.

four. To paper about a corner, leave twenty five mm (a person inch) overlap and “butt” the adjacent strip of paper on to it.

five. Repeat soaking and folding process and provide future roll of paper lining overlapping close to six mm (quarter of an inch) onto the to start with. By getting paper on paper you will prevent the joins from edging into the grooves among bricks.

six. Depart lining paper to dry right away. As it does so it will tighten and stretch out in excess of grooves and rough patches on the wall area.

seven. Ahead of applying wallpaper, coat again with the latex centered wallpaper liquid size as added insurance policy that the lining paper has sealed properly and tightened on to the wall

8. The style of wallpaper employed is critical. It really should be embossed or a large all-natural weave to guarantee that the imprint of the style and design is not lost when pasted on.

nine. Hang your chosen wallpaper vertically in the usual way.

Sit back again and admire your masterpiece.

Source by Darryl Alfred Jackson – http://ezinearticles.com/?How-to-Wallpaper-Over-a-Brick-or-Cement-Block-Wall&id=6356217